2. You then need to perform a data exchange (send all the changes to the pocket pc). For detailed information about that please see "How do I download data to my pocket pc?"
3. On the Pocket PC start the OmniLink program by clinking Start > Programs> Omnilock Link. (Sometimes, Omnilock Link will be right under the start Menu.)
4. Align the infrared port on the Pocket PC with the infrared port on the lockset. If you are unsure about the whereabouts of the IR on your Pocket PC, please consult the user's manual for the pocket pc.
5. Maintain a 6-8 inch distance from the lock when programming. Failure to do so may result in erroneous programming of the lock.
6. Enter the current Programmer Code or Card into the lock. If it is in factory default, the current code is 1-2-3-4. If you have already programmed the lock once and have not reset it since, use the Programmer Code or Card that you defined in your setup.
*** DO NOT MOVE THE POCKET PC ***
7. If your lock is no longer in the factory settings and has already been set to your new Master Code or Card, skip to step 11.
8. Your Pocket PC should present you with a dialog similar to the one below. At this point, you must navigate through any locations until you see the lock you wish to program on the bottom of the screen.
9. Tap on the lock you want to program on the bottom until it is highlighted.
10. Click "OK."
11. The Pocket PC should beginning logging on and programming.
12. When you see the message "Data Exchange Complete," tap OK and close the OmniLink application.
13. You may now move the Pocket PC away from the lock.
14. Return the Pocket PC to its cradle or sync cable and hit the lightening bolt one final time to complete the data exchange. The Data Exchange Dialog on the OFM should be empty at this point.
Add to favorites